DX8 AirWare 2.05 verfügbar


  • [*]Added support for GPS and High Current telemetry sensors.
  • Enabled up to 32-pole motors for the brushless RPM sensor.
    [*]Enabled SD telemetry log file
  • Enabled ability to configure inactivity timer
  • Enabled backlight configurability (Auto/On/Off)
  • Enabled dimming control of the orange Spektrum LED for night flying
  • Adjusted vibe motor RPM to be less aggressive

Software Corrections
  • Fixed bug that could reset the radio when scrolling through Mix options.
  • Corrected L/R trimmer ‘forgetting’ assignment after power cycle.
  • Improved translations in French and Italian screens.
  • Corrected export of flap configuration.
  • Corrected over-travel of flaps that could result in reversed operation at extreme deployments.
  • Corrected switch change on Acro throttle cut screen when going from the initial switch selection to the edit page.
  • Corrected timer to work properly in Throttle Out mode when using reversed throttle channel.
  • Corrected end-point adjustability when Trainer is used as an input to a channel.
  • Corrected trainer normal Master mode so that it doesn’t modify controls from the slave. In previous versions it could reverse channels vs. what was expected.
 

  • [*]Added support for GPS and High Current telemetry sensors.
  • Enabled up to 32-pole motors for the brushless RPM sensor.
    [*]Enabled SD telemetry log file
  • Enabled ability to configure inactivity timer
  • Enabled backlight configurability (Auto/On/Off)
  • Enabled dimming control of the orange Spektrum LED for night flying
  • Adjusted vibe motor RPM to be less aggressive

Software Corrections
  • Fixed bug that could reset the radio when scrolling through Mix options.
  • Corrected L/R trimmer ‘forgetting’ assignment after power cycle.
  • Improved translations in French and Italian screens.
  • Corrected export of flap configuration.
  • Corrected over-travel of flaps that could result in reversed operation at extreme deployments.
  • Corrected switch change on Acro throttle cut screen when going from the initial switch selection to the edit page.
  • Corrected timer to work properly in Throttle Out mode when using reversed throttle channel.
  • Corrected end-point adjustability when Trainer is used as an input to a channel.
  • Corrected trainer normal Master mode so that it doesn’t modify controls from the slave. In previous versions it could reverse channels vs. what was expected.

Was noch zu erwähnen ist, dass man nach dem Update seine Trimmungen und Sub-Trimmungen überprüfen sollte, da sich hier die Auflösung geändert hat (wohl angeglichen an die DX10 + DX18).

Gruß Marcel
 

sa4210

User
wenn man schon eine deutsche Software hat bei der DX8, dann wär halt auch schön, wenn die Updateänderungen ebenso in deutsch zu lesen wären.

Wird aber nix anderes übrig bleiben, als alles schön langsam zum übersetzen zu versuchen.


Andreas
 
Ansicht hell / dunkel umschalten
Oben Unten