Graupner mx16s programming

Hello to everybody
How can i programme an mx16s switch to do engine cut-off instead of put my finger to cut the exaust? a help appart from reading the instructions (which honnestly doesnt say a word at all about it ) would be very helpfull!!!
thanks in advance
Dragan

Well you could programm a free mixer and assign a switch of your choice to it.
When you flip the switch the throttle servo will cut off the motor!

http://www.graupner.de/fileadmin/downloadcenter/anleitungen/20070222092922_4701_GB.pdf

On site 77 you'll find free mixers and how to use them. Just assign a switch to the desired channel.

Just ask if you need help !

Normaly you're doing an engine stop with the trim. You can read it on Page 26 of the above posted pdf instructions.

Thank you JAyThaRevo and Viper 2097 for your help. The programming was successful in the free mixers menu

Best regards
Dragan