Competitionflieger
User
Hallo
habe da eine Lift Off XS von Simprop. Als Motorisierung habe ich vorerst folgende Komponenten:
Eflite 60-Amp Pro Brushless ESC + BL 25 Outrunner Motor, 1000Kv
Spezifikationen Regler:
Brake: Yes - programmable
Continuous Maximum Current: 60A with reasonable cooling
Input Voltage: 10.8V–22.2V
Input Connector Types: 13AWG with E-flite® EC3™ connector
Output Connector Types: 13AWG with 3.5mm female gold bullet connectors
Momentary Peak Current: 75A (15 sec)
Length: 3.00 in (76mm)
Width: 1.30 in (33mm)
Height: 0.50 in (13mm)
Weight: 2.3 oz (66 g)
Wire Gauge: 13AWG
Cells w/BEC: 3–6S Li-Po or 9–18 Ni-MH/Ni-Cd
Spezifikationen Motor:
Shaft Diameter 5.5mm
Can Diamete r 36mm
Length with shaf t 73mm
Length without shaft 49mm
leider finde ich keine Angaben über den Prop. Kann mir jemand eine Empfehlung angeben? Alternativ kommt auch noch das Torcster Lift Off Antriebsset in Frage.
Ich möchte vorerst bewusst nicht zu viel in den Antrieb stecken, da ich Hotliner Beginner bin und mich zuerst rantasten möchte.
Danke für die Hilfe
Adrian
habe da eine Lift Off XS von Simprop. Als Motorisierung habe ich vorerst folgende Komponenten:
Eflite 60-Amp Pro Brushless ESC + BL 25 Outrunner Motor, 1000Kv
Spezifikationen Regler:
Brake: Yes - programmable
Continuous Maximum Current: 60A with reasonable cooling
Input Voltage: 10.8V–22.2V
Input Connector Types: 13AWG with E-flite® EC3™ connector
Output Connector Types: 13AWG with 3.5mm female gold bullet connectors
Momentary Peak Current: 75A (15 sec)
Length: 3.00 in (76mm)
Width: 1.30 in (33mm)
Height: 0.50 in (13mm)
Weight: 2.3 oz (66 g)
Wire Gauge: 13AWG
Cells w/BEC: 3–6S Li-Po or 9–18 Ni-MH/Ni-Cd
Spezifikationen Motor:
Shaft Diameter 5.5mm
Can Diamete r 36mm
Length with shaf t 73mm
Length without shaft 49mm
leider finde ich keine Angaben über den Prop. Kann mir jemand eine Empfehlung angeben? Alternativ kommt auch noch das Torcster Lift Off Antriebsset in Frage.
Ich möchte vorerst bewusst nicht zu viel in den Antrieb stecken, da ich Hotliner Beginner bin und mich zuerst rantasten möchte.
Danke für die Hilfe
Adrian