Speedrick
User
Hello,
I recently bought this gyro second hand, and discovered following problem;
With the jumper installed, I only have the red LED for 2-3 times, then nothing... Normally, the LED should become green to initialize the flight controls
If I remove the jumper, and power up then, the red LED flashes 2-3 times, and then the AMBER led flashes, meaning that he's waiting for the input signal.
Moving the AUX switch does not change anything. Moving sticks does not make the servo's move. If I connect the servo's directly to the receiver, they move normally.
Is there anybody with experience on this gyro?
It is OK if you answer in german, i can read it. One writing is a bit of a problem.
Regards,
Eric
I recently bought this gyro second hand, and discovered following problem;
With the jumper installed, I only have the red LED for 2-3 times, then nothing... Normally, the LED should become green to initialize the flight controls
If I remove the jumper, and power up then, the red LED flashes 2-3 times, and then the AMBER led flashes, meaning that he's waiting for the input signal.
Moving the AUX switch does not change anything. Moving sticks does not make the servo's move. If I connect the servo's directly to the receiver, they move normally.
Is there anybody with experience on this gyro?
It is OK if you answer in german, i can read it. One writing is a bit of a problem.
Regards,
Eric