I need help programming an Unisens-e

Hello everyone!
I'm having trouble programming the Unisens-e so it continues to read the mah from the last flight.
No matter which setting I choose for "Kapazität" every time I turn it off starts from 0. Since this is a glider, i'd like to measure the total capacity I use on every flight added up to have the real idea how much juice is left in the batteries.
I'm using a Jeti radio and everything else works fine so I think the problem might be in some other setting but I can't figure it out where.
Any help is greatly appreciated.
Thanks,
Fernando
 
Hi Thomas,
I changed a few things and it seems to work now.
It used to start from 0 every time. I just unchecked all the alarms I didn't need and tried and worked.
And I just connected another one that was working and it did the firmware update and now is doing the same thing: Cry: not sure if there is some change in the new Fw but I have to figure this one out.
One thing I noticed is that the LED is blinking (in sets of 6) and not solid like it says in the manual apparently that is some parameter being out of threshold (whatever that means...: Confused:)
Thanks,
Fernando
 
If it is solved great

Just as a f/u when programming the unisens

Menu: Kapaz.Messung

IMG_0518.PNG
 
Ansicht hell / dunkel umschalten
Oben Unten