Ein frage
Ein frage
Hallo Leute.
Auch ich habe ein styroscheider von Hanszweidrei nach gebaut
Ich habe 4 Sanyo Denki- motoren type 103-546-5049 0.6A und die MDLCNC Steuerung von Letmathe
und die sofware von Hanszweidrei.
Meine Geometriedaten sind :
14,99 Steps pro Millimeter für Motor_1 (SpMM_1)
15,03 Steps pro Millimeter für Motor_2 (SpMM_2)
14,91 Steps pro Millimeter für Motor_3 (SpMM_3)
15,09 Steps pro Millimeter für Motor_4 (SpMM_4)
1000 Abstand Motor_1 zu Motor_2 in Millimeter (Abst_M1_M2)
999 Abstand Motor_3 zu Motor_4 in Millimeter (Abst_M3_M4), sollte etwa so groß wie Abst_M1_M2 sein
1095 Abstand Motor_1 zu Nullpunkt links (L1_Null)
1095 Abstand Motor_2 zu Nullpunkt links (L2_Null)
1098 Abstand Motor_3 zu Nullpunkt rechts (L3_Null), sollte etwa so groß wie L1_Null sein
1098 Abstand Motor_4 zu Nullpunkt rechts (L4_Null), sollte etwa so groß wie L2_Null sein
So fare so good,aber jetz habe ich eine frage an auch und nog meer an Hanszwiedrei.
Wenn ich mit das prog.Handbetrieb mitMaus5 das absetzposition will machen bekom ich eine feler meldung nl :UNGULTIGE GLEITKOMMAOPeration
Was bedeutet das???
Und wahn ich das prog.Handbetrieb mitMaus5 starte bekomme ich die schritte meldung : :Ostseite 0,0 Westseite 0.0
Seillange in schritten:Mot1 1633
Mot2 1638
Mot3 1625
Mot4 1644
Kan das stimmen oder habe ich etwas fals gemacht??
Gusse Harley