smaug
User
Bei einem getakteten BEC sollte Verlustwärme normalerweise kein Problem darstellen. Wichtiger als die Spannung im Eingangsbereich zu messen, wäre die Messung der Ausgangsspannung des BEC's. Wenn trotz 6V im Eingang die Empfänger LED rot zeigt, dann kommt da auf der Ausgangsseite anscheinend nichts raus.
Jürgen
Hallo
Hier ein Auszug aus der Bedienungsanleitung
Spepecifications
Currerrerrent Output
Peak: 10 amps
Continuous:
<12 volts input = 7 amps*
<24 volts input = 5 amps*
*Ratings are determined with a 5mph airflow on the BEC. Servo connectors are not rated for current in excess of 5 amps. Users are encouraged to replace the connectors if more than 5 amp currents are anticipated.
Input Voltage: 5v to 25.2v (2S to 6S LiPo)
LED: LED on indicates proper function of CC BEC. If LED is off, check for proper setup.
Voltage Outptput
Default setting: 5.1 volts. User selectable in 1/10th volt increments between 4.8 and 9 volts.
Castle Link USB Interface required to change output voltage (sold separately).
Low Input Voltage
In the event that the input voltage falls below the desired output voltage, the CC BEC output is essentially equal to the input level.
CC BEC cannot output more voltage than the battery it draws from. The CC BEC will not operate or produce any output when input voltage drops below 4.0 volts.
Die Kühlung eines getakteten BEC's ist also doch ein Faktor falls dieser unter Last genommen wird.
Gruss
Martin
PS: 5 mph für den BEC ok - für die Hangkante dürfen es gerne mehr sein!