Was für Probleme genau?@kaimunich
Sag mal... welchen Spinner hast du eigentlich bei dir drauf ? ich habe jetzt schon 2 100mm Spinner gekauft und die machen beide Probleme bei der Montage. Hast du bei dir die Besfestigung durch die 4 Motor Schrauben oder hält bei dir alles nur 1 zentralschraube??
Naja... bei Spinner Nr.1 war zB. Alu Platte in der mitte zu klein und da hätte ich schlecht 4 löscher bohren könn. Bei Spinner Nr.2, war der spinner nicht zu 100% passend. Also man konnte es an der Bodenplatte minimal bewegen und drehte sich somit nicht ganz sauber. Die Spitze eierte quasi 2mm, statt sauber zu drehen. Keine Ahnung, ob das schlimm ist. Habe da jetzt einen dritten 100mm und da passt alles.Was für Probleme genau?
Bei den ganzen 3D Kisten hast du im Grunde einen riesigen Spielraum für den Schwerpunkt. Fliegen wird das immer außer du hast nur winzige Ausschläge eingestellt. Der Rest ist dann persönliche Präferenz und ausprobieren.The range for the center of gravity begins at 7 inches from the leading edge of the wing measured at the
root and extends back .75"
One of the best ways to fine tune the CG for your aircraft is the 45 degree line test. Fly the aircraft in
front of you from left to right (or right to left if you prefer) at full throttle. Pull the aircraft into a 45
degree up line and establish this line. Roll the aircraft inverted, neutralize the elevator and pay close
attention to what the plane does. Ideally the plane will continue on this line for several hundred feet
before it starts to slowly level off. If the airplane immediately drops the nose and dives toward the ground
it is nose heavy. If it begins to climb inverted toward the gear it is tail heavy. There is no need to have the
Extra excessively tail heavy to perform 3D maneuvers.
24x12 CfKWelchen Prop nutzt ihr?
Es geht hier auch um absolute Leistungsoptimierung.
Da könnte man mit dem GA 8000 nochmal zusätzliche Power abrufen.
Die EF 85" Modelle werden ja auch mit dem leichten GA4000 geflogen. Der ist jedoch nur bis 4300W gelistet.
Wie wäre es mit 780gr und bis zu 6000W ?
Keine Ahnung wie der Motor zu bewerten ist, bin einfach letzthin drüber gestolpert. Falls das realistisch ist, ergäben sich daraus neue Möglichkeiten.
Hier nach zu lesen